Read or Download Apple Color StyleWriter 4100 4500 Service Source PDF
Similar nonfiction_1 books
Packed filled with functional suggestion on the way to hold and advance vital consumers. Covers the entire precious talents, from unique presentation and negotiation ideas, via account motion plans and improvement of the connection.
- The Elliot Wave Theorist (February 2000 issue)
- This Is Real and You Are Completely Unprepared: The Days of Awe as a Journey of Transformation
- The generalized Stieltjes transform and its inverse
- Golubev series and analyticity in the neighborhood of a continuum
- Remarks on a Hardy-Sobolev inequality
Additional info for Apple Color StyleWriter 4100 4500 Service Source
Lift and remove the bracket from the printer. Note: Once the ground bracket is removed, the remaining parts comprise the mechanical assembly. The base is not included with the mechanical assembly. Ground Bracket Take Apart Sensor Board - 26 Sensor Board Before you begin, remove the following: • Output tray • Banner lever • Length adjuster • Input tray • I/O cover • Top cover • Logic board • Ground Bracket Sensor Board Caution: Review the ESD precautions in Bulletins/ Safety. Take Apart Sensor Board - 27 1 2 Latch Latch Sensor Board Spread the latches outward.
Repeat step at opening #2. Pull length adjuster from top cover. Take Apart Input Tray - 8 Input Tray Before you begin, remove the output tray. Take Apart Input Tray - 9 1 2 Set the printer down on its base. Using a T-20 Torx screwdriver, remove the two screws from the Input Tray. Note: To remove all remaining screws inside the printer, use a T-10 Torx screwdriver. Screw Input Tray Screw Take Apart I/O Cover - 10 I/O Cover No preliminary steps are required before you begin this procedure. I/O Cover Take Apart I/O Cover - 11 1 2 Hole 3 4 Hole I/O Cover Rest the printer on its side.
Disconnect the remaining four cables: • J9: Carriage Motor • J10: Service Station • J11: Sensor board • J12: Paper motor ± Screw Screw J9 J10 J11 J12 Warning: Connector J9 should be removed carefully to prevent the connector from pulling apart. Take Apart Logic Board - 23 3 Ribbon cables 4 Screw Screw Screw Screw Screw J9 J10 J11 J12 Using a T-10 Torx screwdriver, remove the four mounting screws. Remove the logic board from the printer. Take Apart Ground Bracket - 24 Ground Bracket Before you begin, remove the following: • Output tray • Banner lever • Length adjuster • Input tray • I/O cover • Top cover • Logic board Ground Bracket Take Apart Ground Bracket - 25 Screw Screw 1 2 Remove the two screws from the ground bracket.